For accurate measurement of bore diameter, taper and ovality.
The measurement is taken by 2 hardened steel anvils (1 fixed, 1 movable) which are automatically centred in the bore by a separate spring loaded guide.
The movable anvil is connected to a push rod inside the body of the instrument which operates a dial gauge at the opposite end.
A set of different length anvils and in some cases, extension tubes, enable a wide range of bore diameters to be measured.
The instrument must be calibrated to a known dimension before use; e.g. with an outside micrometer, setting ring etc.
Range: 18-35mm
Depth: 140mm
Resolution: 0.01mm
Accuracy: 15um
Set Includes:
Dial Gauge 0-3mm
Measuring Head with Gauge Clamp
7 Contact Points
1 Spacing Washer
1 Locknut
Spanner