2018 GF Gordini TCS80 Flail Mulcher to suit 3-6t Excavator, Tom Price WA

2018 GF Gordini TCS80 hydraulic flail mulcher, Italian built, to suit 3 to 6 tonne excavators. Serial number 00487.

This unit has done very little work. We bought it for a specific job, ran it for roughly a week, and it has been sitting since. Bearings and hydraulic motor are effectively as new.

Being honest about the condition, it has been stored outside in the Pilbara and the paint and surface steel show it. There is surface rust across the housing and the rotor. That is cosmetic weathering, not wear. If you look at the rotor and the hammers in the photos you can see there is almost no material worn off them. There is one pin and bush that needs replacing, which we have allowed for in the asking price.

Specifications:
- 800 mm working width
- 245 kg
- Flow rate range 30 to 60 litres per minute, optimal 35 to 45
- Maximum oil pressure 220 bar
- Maximum cut diameter approximately 40 mm
- Swinging hammer rotor
- Suits 3 to 6 tonne excavators

Currently set up with an excavator top bracket. The photos show the hitch arrangement clearly, so please check it against your machine before purchase. A new top bracket to suit a different carrier is a straightforward workshop job.

For reference, this model currently sells new in Australia at around $11,850 plus GST before you add a hitch and hoses.

Why we are selling: we are rationalising the fleet and this head is sized for an excavator rather than the machines we are running now. It is the right tool for someone with a 3 to 6 tonne excavator doing vegetation clearing, firebreaks, drain and verge maintenance or general land clearing.

Located in Tom Price, Western Australia. Inspection welcome. We can organise free delivery to Perth if required.

$6,000 ex GST firm.