S Models (Basic 70 Series feeders)
Wire speed control.
Factory-set run-in control for improved arc starts.
24 VDC high-torque, permanent-magnet motor.
Quick-release, drive-roll pressure adjustment arm allows drive roll change without losing spring preload setting.
Solid-state speed control and brake circuit for increased service life.
Floating positive drive systems provide trouble-free feeding on a variety of wires.
D Models Add the Following Features
Digital meters for easy viewing of the wire feed speed and Voltage.
Remote Voltage control allows operator to set Voltage at the wire feeder without having to go back to the power source.
Tachometer feedback to help keep wire feed speed accurate.
DX Models add the Following Features
Four weld programs allow the operators to store four independent welding parameters reducing welding setup time (four programs available per side on dual feeder).
Adjustable run-in control for improved arc starts.
Adjustable weld sequence control gives operator complete control of the welding parameters: pre-flow, run-in, weld time, crater, burn-back and post-flow.
Welding process range control locks parameters at a set percentage of welding parameters to ensure welding procedures and quality standards are maintained on the shop floor.
Dual schedule allows operator to switch between two welding parameters without readjusting the machine, eliminating downtime and enhanching quality.
Leumeah, NSW
******5200 
