This machine was installed in late 2012 as a 4 axis machine and has had Mazak software upgrades to become a full 5 axis continuous machine. The machine has only worked single shifts and has been a jobbing machine, never used for mass production.
There is an extensive range of tooling holders and work holding equipment with the machine, including a large rotary plate, tail stock, tombstones, vee blocks, packers, clamps, vices and three BAC tool storage cabinets.
The machine has also been fitted with a large Hydac coolant filtration unit and a high pressure coolant pump for deep hole drilling. This high pressure unit supplies coolant at up to 170Bar for deep hole drilling. This high pressure unit is connected as required and is not in use every day.
• Table working surface (L) 3500 mm x (W) 820 mm
• Saddle (longitudinal) X-axis 3000 mm
• Column (cross) Y-axis 800 mm
• Spindle head (vertical travel) Z-axis 720 mm
• Spindle speed maximum 18,000 min
• Rapid traverse (XYZ-axis) 50 m/min
• Tool storage capacity 48 tools (48+ tool holders included with the machine)
• Tool shank BT-40
• Ganro rotary 4th axis, Bison chuck.
• Dividing plate for main table
• Power Requirements: Power Source 415 V, Frequency 50/60 Hz.
• Machine Dimensions
• Width 5250 mm
• Depth 3550 mm
• Height 3152 mm
• Machine Weight (approximate) 15,800 Kg
Facebook
Twitter
Email a Friend
BENTLEY PARK, QLD 
******6319 
Print
