MEP PH261 1 HB Manual Bandsaw

The NEW PH 211-1 and 261-1 replaces models PH 211 and 261, keeping just the same sizes and cutting capacity only.
They offer peerless technical features, having been designed using the valuable manufacturing technology of larger machines.
These manual band sawing machines for cuts from 0º to 60º on the left are also supplied in a version with HB device to make single cuts without operators, still keeping the manual cutting cycle available ( the HB device is available only in the three-phase version)

HB CUTTING CYCLE
After positioning the bar and closing the vice, the cutting phase is started, using the weight of the saw frame controlled by a hydraulic circuit to adjust the downfeed speed; after the cut the band stops, the frame is manually lifted in order to reposition the bar to cut untill the position needed by the operator , at this point the head frame is locked by the manually-controlled hydraulic valve.

A FEW FEATURES:
-NEW sturdy structures in cast iron in order to tension the band at 700 and 900 kg respectively for PH 211-1 and PH 261-1
-Moveable pulley slide with two adjustable gibs to ensure stiffness while cutting.
-Electrical board with entirely identifiable wiring, stand-by, main switch with lock, short circuit protection, motor overload cutout, min. voltage coil, low voltage system 24 V.
-Control handle IP55.
– Driving pulley locked with clamp ring to ensure a strong fastening, still allowing axial adjustment.
– Blade-guide heads with 6 CARBIDE pads instead of bearings to ensure a better stability.
-Stop strokes at 0º and 60º on the left
with lever for locking at any intermediate angle.
-Head articulation with preloaded tapered bearings.
-Vice with fast locking lever.
-Stand with lubricating coolant tank.
-Electric pump for the band lubrication and cooling.
-Brush band-cleaning device.
-Double spring for head return.
-Adjustable stroke for cuts of the same size.
-Bimetallic band for profiles and solid pieces.
-Instructions manual and spare parts list.

Fully complies to Australian safety standards 4024.1