2011 build Radial Arm Drill in excellent condition. Very little use.
Variable speed drive on main motor allowing for any speed selection between 38 and 2000 RPM.
Heavy duty cast iron table with large box table as shown in pictures (angle table not included).
Complete user manual is provided. Fitted with a standard 415V 3phase 5pin 32A plug.
Max. drilling diameter (No.45 steel): 62 mm
Max. drilling diameter (HT200 cast iron): 72 mm
Max tapping diameter(No.45 steel): M46 mm
Max tapping diameter(HT200 cast iron) M52 mm
Distance between column center line to the spindle center line 350 - 1600 mm
Travel distance of the spindle box in horizontal (by manual) 1250 mm
Distance between spindle end face to the machine bottom table 350 - 1250 mm
Max. spindle travel 315 mm
Spindle taper MT5 Morse
Steps of spindle speed step-less
Spindle speed range 38 - 2000 r/min
Steps of spindle feed 8 Steps
Range of the spindle feed rate 0.06 – 1.00 mm/r
Speed of the arm up and down 1.2 m/min
Arm moving angle ±180 degree
Spindle moving distance of each dial revolution 122 mm
Max. spindle torque 400 N.m
Max. spindle feed resistance 16000 N
Main motor power (Frequency conversion motor) 4.0 kW
Power for the arm up and down motor 1.5 kW
Power of clamping oil pump for spindle box, column and arm 0.75 kW
Machine weight (without table) 3800 kg
Machine dimension (L x W x H) 2490×1050×2780 Mm
Dubbo , NSW 
******1932 
